您好,歡迎光臨思孚科技網站!
快拆式萬向節+套筒
專業制造 卓越品質
快拆式萬向節+套筒

參數

品名 型號 連接內孔直徑 外圓直徑
快拆萬向節 C14 對邊12.8 φ29.5
KC08 內孔φ8 φ24.4

萬向節注意事項:
1.調整時不能超過規定的角度15度
2.如超過此極限芯軸易磨損貨斷裂
3.工作時應經常加潤滑油脂

萬向節組裝注意事項
U型多軸器輸出軸組由上下2個萬向節配合六角傳動軸組成,組裝時須注意萬向節內側爪須同一位置,方向,以免造成彎曲偏擺量過大損及其壽命。

ER筒夾尺寸

Name Type Connect I.D.(inner diameter) O.D.(outer diameter)
C14 對邊12.8 φ29.5
Quickset-up cardan joint KC08 內孔φ8 φ24.4

1.Do not set the angle to more than the specified 15 degrees.
2.If the limit is exceeded,the shaft will be easy to wear or break.
3.Duringwork,iubrication be added frequently.

Note of cardan joint installation
The output shafta of the Type Umulti-spindle tool consist of two(up and down)cardan joint and hexagonal driven shafts,When installing,note to have the inner clutches of the cardan joint in the same position and direction,and avoid too much wrestor twist that may cause damage or influence the lifetime.